Julie@nbchengzhao.com

+86-574-87488509

Product Categories
Contact Chengzhao

Address: Room 702, Building 3, No. 636 Duantang East Rd, Pan Asia International, Haishu, Ningbo, China.

TEL: +86-574-87488509

FAX: +86-574-81859847

Email: Julie@nbchengzhao.com

 

Home > News > Content
How To Use The Molding Machine Jul 13, 2017

Forming machine features

(1) molding machine computer using imported PLC host computer chip, match the LCD screen, software backup fault self-diagnosis system and error correction function, the operation more convenient, the control program to fool-style design, no professional training can induction The

(2) molding machine full hydraulic drive, with the domestic first stepless hydraulic FM technology to solve the molding machine on a variety of materials and block type of fitness, Roll Forming Machine improve the material density, shorten the molding cycle.

How to use the molding machine

1, select the flattening table, a steady machine, you can pull the chassis feet to facilitate the observation of the machine panel.

2. Insert the plug on the hand-held head into the socket on the panel and tighten it. Attention to positioning gap

3, plug the end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Roll Forming Machine Be sure to use single-phase three-wire power supply. The same time as the above-

4. Open the "POWER SW." On the rear panel of the chassis and press the "SWITCHING" button on the panel. The "WARM UP" green indicator will light and the machine will work. The same time as the above-

5. Press and hold the "SETTING BUTTON" button to set the appropriate value, usually between 0.5 and 2.0 seconds. The same time as the above-

6, the sensor head on the container cover, press the handle on the start button, then "heating (HEATING)" red light, that is heating, the sensor head do not move away, "HEATING" red light And then remove the sensor head, and so on "WARM UP" green light or the machine buzzer short "beep" prompts and then the next container can be sealed. The same time as the above-

7, check the sealing quality, according to different materials, Roll Forming Machine diameter containers and production efficiency, appropriate dressing "set button (SETTING BUTTON) button, making the best quality sealing.

The operation of the molding machine:

1, before the boot, first of all to check the machine for debris, or there is no need to clean the machine near the machine will affect the normal production of the object;

2, to the molding machine need to lubricate the components plus lubricants, such as gears, bearings, cutter and so on. If there is a punching equipment, Roll Forming Machine punching equipment should be the guide column, as well as punching the various parts of the mold to add lubricants;

3, molding machine production before the test. Home page to open the power switch, manually operate the various functions are normal;

4, began to feed production, after testing the normal function of the test, began to feed production, in the production process at any time attention to the entire production line may appear emergency situation. Production time, the machine can not stand;

5, in the discharge port material, according to their own work speed adjustment molding machine production speed;

6, after the end of the molding machine production, Roll Forming Machine should turn off the power switch, completely cut off the machine power;

7, the cleaning machine to clean up, keep the body clean. As well as the waste generated by the production just to clean up;

8, close the box lock, so as to avoid other unrelated personnel operating the machine, causing damage to the machine.